GMCforum: GMCnet » [GMCnet] Remove Door Panel

Home » Public Forums » GMCnet » [GMCnet] Remove Door Panel

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Remove Door Panel [message #103675]

Thu, 21 October 2010 10:09

USAussie

Messages: 15912
Registered: July 2007
Location: Sydney, Australia

Karma: 6

Senior Member

G'day,

I found a perfect door handle to attach to the door panel at Lowe's
yesterday that will fit between the center panel and the Birch screen door.

I checked the Parts Book 78Z page 23-36 and can see that I need to remove
the panels above and below the center panel.

To remove the center panel it appears that I need to remove four screws (key
36), four screws (Key 33), and the knob (Key 28).

Have I got it right or have I missed something? Any traps or tricks doing
this?

Thanks,
Rob M.
USAussie

_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Regards, Rob M. (USAussie) The Pedantic Mechanic Sydney, Australia '75 Avion - AUS - The Blue Streak TZE365V100428 '75 Avion - USA - Double Trouble TZE365V100426

Report message to a moderator

Re: [GMCnet] Remove Door Panel [message #103676 is a reply to message #103675]

Thu, 21 October 2010 10:20

George Zhookoff

Messages: 398
Registered: December 2004
Location: Snellville, GA

Karma: 6

Senior Member

Rob,
There's also a rod link from the door handle to the door lock latch with
a "c-clip" holding the link to the latch.
IIRC
George Zhookoff
78 EL II
Atlanta

Subject: [GMCnet] Remove Door Panel

G'day,

I found a perfect door handle to attach to the door panel at Lowe's
yesterday that will fit between the center panel and the Birch screen
door.

I checked the Parts Book 78Z page 23-36 and can see that I need to
remove
the panels above and below the center panel.

To remove the center panel it appears that I need to remove four screws
(key
36), four screws (Key 33), and the knob (Key 28).

Have I got it right or have I missed something? Any traps or tricks
doing
this?

Thanks,
Rob M.
USAussie
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

Previous Topic:	Torsion Bar tool drawing
Next Topic:	[GMCnet] Onan Paint

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Nov 02 02:22:19 CDT 2024

Total time taken to generate the page: 0.01580 seconds