[GMCnet] O Ring [message #98659] |
Sun, 05 September 2010 15:14 |
paul h cashman
Messages: 176 Registered: May 2005
Karma: 0
|
Senior Member |
|
|
Hi All,
Before installing my new Transmission Filter ,I thought ,I would check ,the
Manual.
The Manual says ,to install one O rind in the Bore ,then install the Filter
When I removed the old Filter ,one O Ring was on the Filter and the other
one was in the Bore.
On other ,Automobile.Transmission Filters I have worked on,the O rings were
always installed on the Filter.
Is Manny saying to put both O Rings in the bore first,then drive the Filter
through the O Rings,or just butt it up, till it makes contact with the O
Rings.?
Thanks.
Paul Cashman
Riverdale GA
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Paul H Cashman
Riverdale Ga
1978 Transmode
1975 Corvette
1978 Beetle Convertible
1989 Harley Davidson Sportster
|
|
|
Re: [GMCnet] O Ring [message #98664 is a reply to message #98659] |
Sun, 05 September 2010 17:39 |
fred v
Messages: 999 Registered: April 2006 Location: pensacola, fl.
Karma: 0
|
Senior Member |
|
|
my experience is that if you stick the ring up the hole you won't know if the filter goes center into the ring or catches an edge and upsets it shoving half of it further up the hole. if you put it on the filter and shove it up the hole you will know it goes in right.
Fred V
'77 Royale RB 455
P'cola, Fl
|
|
|
Re: [GMCnet] O Ring [message #98665 is a reply to message #98659] |
Sun, 05 September 2010 17:49 |
|
JShot
Messages: 485 Registered: October 2006 Location: NW Ohio
Karma: 0
|
Senior Member |
|
|
paul h cashman wrote on Sun, 05 September 2010 16:14 |
Is Manny saying to put both O Rings in the bore first,then drive the Filter
through the O Rings,or just butt it up, till it makes contact with the O
Rings.?
Thanks.
Paul Cashman
Riverdale GA
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
Paul,
I just did mine a couple weeks ago - I put the new ring on the 'filter' to the stop, then put one of the old rings on top of that, then slid it into the hole in the tranny. I stayed up there while I put the pan on. HTH,
John
John Shotwell
Ridgeville Corners, OH
78 Royale Center Kitchen
|
|
|