Got the spinning cabinet bolt out [message #98553] |
Sat, 04 September 2010 19:14 |
JohnL455
Messages: 4447 Registered: October 2006 Location: Woodstock, IL
Karma: 12
|
Senior Member |
|
|
I brought my coach home today out of storage to start to get ready for Southern Ill. In our last episode, I was trying to remove the overhead cabinets to install new drapes and the right rear had a spinning press nut. After prying while ratcheting to no avail and with the threads too recessed to get Kroil into them, I gave it a shot with the Milawaukee hammer drill on full high speed in alternating directions while applying pry pressure. The 7/16 head bolt finally got hot enough to spin in the thread and is out. That's one way to apply heat without a torch! Not touchable without a burn it was so hot. Now I have to JB weld the spinning nut and should be good. This might help someone with the same problem.
John Lebetski
Woodstock, IL
77 Eleganza II
|
|
|