Type of paint [message #95323] |
Wed, 11 August 2010 10:37 |
|
cbwoodsr
Messages: 1063 Registered: February 2004
Karma: 0
|
Senior Member |
|
|
How can you tell if the paint the PO had done is lacquer or enamel..
It's needing a wax job, and it's not fun doing it by hand.
The top is a faded gray which is running down the side when it rains.
Wanted to at least sand it done and redo it, but dont know whether to use lacquer or enamel.
Was just going to use spray can white.
Thankx
CBWood
77 Kingslay
MWC OK
ONLINE PARTS PROGRAM
www.GMCMHParts.com
|
|
|
|
Re: [GMCnet] Type of paint [message #95336 is a reply to message #95326] |
Wed, 11 August 2010 13:14 |
gmcrv1
Messages: 839 Registered: August 2007 Location: Memphis
Karma: -1
|
Senior Member |
|
|
Take a little lacquer thinner and test a small area inside the propane or
gen set door. If no color comes off you probably have Imron or some other
urethane type paint. If you''re going to repaint, Dupont made a
product that I think was called primer/sealer/surfacer 100S. Depending on
what you used as the thinning solvent, it could be used as any one of the
above, I took a brand new E150 Ford years back and two toned it with
lacquer over factory fresh (less than 5 months old) enamel using the 100S as
a sealer. They said it couldn't be done. Looked great even 10 years
later. I got the idea from one of the hot rod magazines. I'm sure your
local paint supply house could help you out. Or try web sites for Dupont, R
& M Sherwin Williams etc.
Good luck,
Tom Eckert N2VWN
73 Glacier
O9akland, TN
On Wed, Aug 11, 2010 at 11:25 AM, David H. Jarvis <jarvis210@shaw.ca> wrote:
>
>
> Laquer hasn't been used for many years. As it gets older, you would see
> small "weather checks" in it. Chances are it's an oil base paint. Use a
> buffer made just for auto paint. It runs much slower than others. You can
> get liquid polish and squirt it on, then buff.
> --
> "I've always been crazy, but it kept me from going insane"
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
Re: [GMCnet] Type of paint [message #95396 is a reply to message #95336] |
Wed, 11 August 2010 20:30 |
Arthur Mansfield
Messages: 290 Registered: April 2010
Karma: 0
|
Senior Member |
|
|
I do not know what yours is painted with. I checked a few years ago in the manual and it said do not use lacquer. To use lacquer it would require a good sealer then I assume lacquer would be ok and stated by Tom.
Art & Doris
76 EL
On Aug 11, 2010, at 12:14 PM, Tom Eckert wrote:
> Take a little lacquer thinner and test a small area inside the propane or
> gen set door. If no color comes off you probably have Imron or some other
> urethane type paint. If you''re going to repaint, Dupont made a
> product that I think was called primer/sealer/surfacer 100S. Depending on
> what you used as the thinning solvent, it could be used as any one of the
> above, I took a brand new E150 Ford years back and two toned it with
> lacquer over factory fresh (less than 5 months old) enamel using the 100S as
> a sealer. They said it couldn't be done. Looked great even 10 years
> later. I got the idea from one of the hot rod magazines. I'm sure your
> local paint supply house could help you out. Or try web sites for Dupont, R
> & M Sherwin Williams etc.
>
> Good luck,
>
> Tom Eckert N2VWN
> 73 Glacier
> O9akland, TN
>
> On Wed, Aug 11, 2010 at 11:25 AM, David H. Jarvis <jarvis210@shaw.ca> wrote:
>
>>
>>
>> Laquer hasn't been used for many years. As it gets older, you would see
>> small "weather checks" in it. Chances are it's an oil base paint. Use a
>> buffer made just for auto paint. It runs much slower than others. You can
>> get liquid polish and squirt it on, then buff.
>> --
>> "I've always been crazy, but it kept me from going insane"
>> _______________________________________________
>> GMCnet mailing list
>> List Information and Subscription Options:
>> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>>
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
Re: [GMCnet] Type of paint [message #95399 is a reply to message #95396] |
Wed, 11 August 2010 20:37 |
gmcrv1
Messages: 839 Registered: August 2007 Location: Memphis
Karma: -1
|
Senior Member |
|
|
Again, that was years ago and paint technology has progressed by leaps and
bounds. I have seen clear coat applied over base coats that any refinisher
years ago would have a heart attack. Either way, it's all in the prep.
Another piece of advice from my Dad who for over 40 years was a custom
finisher told me "Whatever product you use - use all of the component
materials from the same manufacturer". Dupont primer, Dupont sealer, Dupont
thinners, Dupont base & clear coats - very important to stay within the
manufacturere's product line.
Tom Eckert N2VWN
73 Glacier
Oakland, TN
On Wed, Aug 11, 2010 at 9:28 PM, Arthur Mansfield <1104agm@gmail.com> wrote:
> I do not know what yours is painted with. I checked a few years ago in the
> manual and it said do not use lacquer. To use lacquer it would require a
> good sealer then I assume lacquer would be ok and stated by Tom.
>
> Art & Doris
> 76 EL
> On Aug 11, 2010, at 12:14 PM, Tom Eckert wrote:
>
> > Take a little lacquer thinner and test a small area inside the propane or
> > gen set door. If no color comes off you probably have Imron or some
> other
> > urethane type paint. If you''re going to repaint, Dupont made a
> > product that I think was called primer/sealer/surfacer 100S. Depending
> on
> > what you used as the thinning solvent, it could be used as any one of the
> > above, I took a brand new E150 Ford years back and two toned it with
> > lacquer over factory fresh (less than 5 months old) enamel using the 100S
> as
> > a sealer. They said it couldn't be done. Looked great even 10 years
> > later. I got the idea from one of the hot rod magazines. I'm sure your
> > local paint supply house could help you out. Or try web sites for
> Dupont, R
> > & M Sherwin Williams etc.
> >
> > Good luck,
> >
> > Tom Eckert N2VWN
> > 73 Glacier
> > O9akland, TN
> >
> > On Wed, Aug 11, 2010 at 11:25 AM, David H. Jarvis <jarvis210@shaw.ca>
> wrote:
> >
> >>
> >>
> >> Laquer hasn't been used for many years. As it gets older, you would see
> >> small "weather checks" in it. Chances are it's an oil base paint. Use a
> >> buffer made just for auto paint. It runs much slower than others. You
> can
> >> get liquid polish and squirt it on, then buff.
> >> --
> >> "I've always been crazy, but it kept me from going insane"
> >> _______________________________________________
> >> GMCnet mailing list
> >> List Information and Subscription Options:
> >> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
> >>
> > _______________________________________________
> > GMCnet mailing list
> > List Information and Subscription Options:
> > http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
Re: Type of paint [message #95406 is a reply to message #95323] |
Wed, 11 August 2010 20:59 |
JohnL455
Messages: 4447 Registered: October 2006 Location: Woodstock, IL
Karma: 12
|
Senior Member |
|
|
I used Centari enamel to fix some bad spots. It went on great over the Immeron as well as on areas that had been previously repaired and were unknown type of paint.
John Lebetski
Woodstock, IL
77 Eleganza II
|
|
|
|
Re: Type of paint [message #95449 is a reply to message #95323] |
Thu, 12 August 2010 05:48 |
Rusty
Messages: 197 Registered: October 2005 Location: Philadelphia Pa
Karma: 0
|
Senior Member |
|
|
I thought after I had my coach painted at TG last year I would be able to never see the faded grey streaks from rain, running down the side, ever again. Wrong. I've come to the conclusion they are from pollen or dust in the air. The new paint however, makes those streaks a whole lot easier to wipe off.
Rusty
75 Glenbrook
Philadelphia Pa
|
|
|