| Re: [GMCnet] hub bolt torque [message #76327] |
Thu, 11 March 2010 11:16 |
Steven Ferguson
Messages: 3447
Registered: May 2006
Karma: 0
|
Senior Member |
|
|
That is not correct Jay (I'm not Carl). Follow the installation
instructions for proper torque. You are tightening the nuts on the
original wheel studs, but tightening against aluminum, vice the OEM
steel wheels. If you're not sure, give Jim a call or whoever you
purchased the spacers from.
On Thu, Mar 11, 2010 at 10:09 AM, Jay Rabe <jayrabe@hotmail.com> wrote:
>
> Thanks Carl,
>
> I'd guess the most important thing for installing the hub spacers is that I put them on with higher torque than I'm going to use on the wheels. Right?
>
> J
>
>
>
>> Date: Thu, 11 Mar 2010 07:02:10 -0800
>> From: carljr3b@yahoo.com
>> To: gmclist@temp.gmcnet.org
>> Subject: [GMCnet] hub bolt torque
>>
>> Jay,
>>
>> I agree with Steve on this. Especially since you are a self proclaimed "novice Mechanic". The only way to know, for sure, that you have the proper amount of torque on a fastener is to measure it with a torque wrench. I know Dan Gregg knocked himself out when his 3/4" Chinese torque wrench broke, but I have used the one that the PO included with my coach (Harbor Freight) with no such problems. My Craftsman 1'2" drive only reads up to 150 lbs so you will need a bigger one than that. There has been some discussion on the amount of torque that should be applied to the lug nuts, with some saying that the 250 lbs specified, is too much and will over stress the lug bolts. I have used a torque of 150 - 175 lbs, with anti-seize on the threads, successfully with no sign of loosening.
>>
>> Carl S. '75 ex-Palm Beach, Tucson, AZ.
>>
>
>
> _________________________________________________________________
> Hotmail: Powerful Free email with security by Microsoft.
> http://clk.atdmt.com/GBL/go/201469230/direct/01/
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
--
Steve Ferguson
'76 EII
Sierra Vista, AZ
Urethane bushing source
www.bdub.net/ferguson/
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
