GMCforum: GMCnet » Height Control Valve Link Assembly

Home » Public Forums » GMCnet » Height Control Valve Link Assembly

Show: Today's Messages :: Polls :: Message Navigator

Height Control Valve Link Assembly [message #361578]

Sat, 09 January 2021 16:50

Tom Katzenberger

Messages: 399
Registered: June 2019
Location: Kingsville, MD

Karma: 4

Senior Member

Can I steel the parts and size information from someone with regard to the Height Control Valve Link Assembly? I am looking to fab one using (2) rod ends, jamb nuts and a long hex fitting. I sure many have already constructed this many times over in the past.

Thanks all and take care,
Tom

Tom & Oki Katzenberger, Kingsville, Maryland, 1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition

Report message to a moderator

Re: Height Control Valve Link Assembly [message #361579 is a reply to message #361578]

Sat, 09 January 2021 16:52

Tom Katzenberger

Messages: 399
Registered: June 2019
Location: Kingsville, MD

Karma: 4

Senior Member

Guys,

I am very sorry for the duplicate posts. Computer issue on my end.

Report message to a moderator

Re: Height Control Valve Link Assembly [message #361580 is a reply to message #361578]

Sat, 09 January 2021 17:00

C Boyd

Messages: 2629
Registered: April 2006

Karma: 18

Senior Member

Sir, I used adjustable turn buckles from Home Depot. 1/4” I think.

Tom Katzenberger wrote on Sat, 09 January 2021 17:50

Can I steel the parts and size information from someone with regard to the Height Control Valve Link Assembly? I am looking to fab one using (2) rod ends, jamb nuts and a long hex fitting. I sure many have already constructed this many times over in the past.

Thanks all and take care,
Tom

C. Boyd
76 Crestmont
East Tennessee

Report message to a moderator

Re: Height Control Valve Link Assembly [message #361583 is a reply to message #361580]

Sat, 09 January 2021 17:04

C Boyd

Messages: 2629
Registered: April 2006

Karma: 18

Senior Member

5/16 “ maybe ?

C Boyd wrote on Sat, 09 January 2021 18:00

Sir, I used adjustable turn buckles from Home Depot. 1/4” I think.

Tom Katzenberger wrote on Sat, 09 January 2021 17:50
Can I steel the parts and size information from someone with regard to the Height Control Valve Link Assembly? I am looking to fab one using (2) rod ends, jamb nuts and a long hex fitting. I sure many have already constructed this many times over in the past.

Thanks all and take care,
Tom

C. Boyd
76 Crestmont
East Tennessee

Report message to a moderator

Previous Topic:	[GMCnet] Remove political posters
Next Topic:	Sol-Aire furnace

Goto Forum:

-=] Back to Top [=-

Current Time: Sun Jul 07 22:30:28 CDT 2024

Total time taken to generate the page: 0.02085 seconds