|
Re: Socket size (12 pt) for front axle output hub bolts? [message #367982 is a reply to message #364980] |
Sun, 12 December 2021 18:04 |
jhbridges
Messages: 8412 Registered: May 2011 Location: Braselton ga
Karma: -74
|
Senior Member |
|
|
I went down to the 'bolt room' at Coker Equipment in Gainesville with a sample. The Bolt Lady wander down a row and pulled out a sample, 12 hardness, 40 cents per. I had kept the original think washers and they had them as well. Red loctite and two hex drivers - they were the same diameter head and surface but were hex drive. The NO (Next Owner) hasn't had a problem with tjhem that I've heard of, after the many miles I put on the coach before I sold it.
Why Coker has such a good inventory in North Georgia of fasteners, I dunno, but pretty much anything that holds two things together they have and the Bolt Lady knows where on the roughly thousand feet of floor to ceiling bins it resides.
--johnny
Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
I forgive them all, save those who hurt the dogs. They must answer to me in hell
|
|
|