Re: Valve Covers [message #88519 is a reply to message #88454] |
Mon, 14 June 2010 10:51 |
Carl S.
Messages: 4186 Registered: January 2009 Location: Tucson, AZ.
Karma:
|
Senior Member |
|
|
Chris,
When I did mine, one valve cover had a gasket and the other did not. The one without the gasket had the worse leak. I'm pretty sure GM used gaskets, so this was obviously a PO repair at some point. I used FelPro rubber gaskets with a thin film of Gray permatex RTV applied to both sides. Be careful not to over tighten the screws.
Carl Stouffer
'75 ex Palm Beach
Tucson, AZ.
Chuck Aulgur Reaction Arm Disc Brakes, Quadrabags, 3.70 LSD final drive, Lenzi knuckles/hubs, Dodge Truck 16" X 8" front wheels, Rear American Eagles, Solar battery charging. GMCSJ and GMCMI member
|
|
|