GMCforum: GMCnet » [GMCnet] Chevy 1-ton Front Hubs for the GMC by Bill Hubler

Home » Public Forums » GMCnet » [GMCnet] Chevy 1-ton Front Hubs for the GMC by Bill Hubler

Show: Today's Messages :: Polls :: Message Navigator

Re: [GMCnet] Chevy 1-ton Front Hubs for the GMC by Bill Hubler [message #88496 is a reply to message #88033]

Mon, 14 June 2010 06:00

g.winger

Messages: 792
Registered: February 2008
Location: Warrenton,Missouri

Karma:

Senior Member

Never did an alignment on the GMC. Not an expert, I've maintained and ran the machines that have done 2.2 Million alignments since 1995. So I did my own alignment when I changed to the Hubler conversion. Got 3 3/4 degrees of caster. Thats without offsets. I used Steve F. upper and lower urethane's. Hope this helps,,,PL

Report message to a moderator

[Message index]

		[GMCnet] Chevy 1-ton Front Hubs for the GMC by Bill Hubler By: Mr ERFisher on Fri, 11 June 2010 05:18
		Re: [GMCnet] Chevy 1-ton Front Hubs for the GMC by Bill Hubler By: jim kanomata on Sat, 12 June 2010 18:11
		Re: [GMCnet] Chevy 1-ton Front Hubs for the GMC by Bill Hubler By: ljdavick on Mon, 14 June 2010 01:11
		Re: [GMCnet] Chevy 1-ton Front Hubs for the GMC by Bill Hubler By: g.winger on Mon, 14 June 2010 06:00
		Re: [GMCnet] Chevy 1-ton Front Hubs for the GMC by Bill Hubler By: jimk on Mon, 14 June 2010 21:49

Previous Topic:	New Tail Wag/Sway problem
Next Topic:	[GMCnet] how is the rear ladder attached?

Goto Forum:

-=] Back to Top [=-

Current Time: Mon Jul 08 07:36:07 CDT 2024

Total time taken to generate the page: 0.00946 seconds