GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] ride height adjustment
Re: [GMCnet] Ride Height Adjustment [message #88051 is a reply to message #88050] Fri, 11 June 2010 10:22 Go to previous messageGo to previous message
USAussie is currently offline  USAussie   United States
Messages: 15912
Registered: July 2007
Location: Sydney, Australia
Karma:
Senior Member
Ken B.,

I just got off the phone with Ken F. and I got it somewhat wrong or right
depends on how you look at it.

Ken said he sets up the coach level. He starts by setting the rear ride
height so that a line extending from the center of rear axle spindle going
forward intersects with the center of the two bogie pivots and through the
center of the middle axle spindle.

He then adjusts the torsion bars to set the frame level.

He says that this will "just about" make the front axles level or the inner
CV joints will be a bit higher than the outer as long as the engine mounts
are not shot.

Regards,
Rob Mueller
Sydney, Australia
AUS '75 Avion-The Blue Streak TZE365V100428
USA '75 Avion-Double Trouble TZE365V100426

-----Original Message-----
From: Ken Burton

You probably heard correctly since Emery stated the same thing. Both of
these people are very knowledgeable on the GMC and people I trust. I would
just like to see this in writing from GM.
--
Ken Burton

_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist



Regards, Rob M. (USAussie) The Pedantic Mechanic Sydney, Australia '75 Avion - AUS - The Blue Streak TZE365V100428 '75 Avion - USA - Double Trouble TZE365V100426
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Major Typo's (or CRS in action)
Next Topic: Finding your GMC with Google Earth Street view
Goto Forum:
  


Current Time: Fri Jul 05 09:31:25 CDT 2024

Total time taken to generate the page: 0.00809 seconds