GMCforum: GMCnet » [GMCnet] Master Cylinder Pushrod Clearance

Home » Public Forums » GMCnet » [GMCnet] Master Cylinder Pushrod Clearance

Show: Today's Messages :: Polls :: Message Navigator

Re: [GMCnet] Master Cylinder Push rod Clearance [message #78055 is a reply to message #78052]

Thu, 25 March 2010 21:34

roy1

Messages: 2126
Registered: July 2004
Location: Minden nevada

Karma:

Senior Member

I tend to agree with Jim around 1/16" should be good. This is something I have dealt with for the past 45 years messing with street rods any time you mix and match master cylinders to hot rods firewalls or different power units and swing pedals you always have to make sure there is a little free play in the rod.
The GMC is no different.
Roy

Roy Keen Minden,NV 76 X Glenbrook

Report message to a moderator

[Message index]

		[GMCnet] Master Cylinder Pushrod Clearance By: Gary Bovee on Thu, 25 March 2010 21:04
		Re: [GMCnet] Master Cylinder Push rod Clearance By: roy1 on Thu, 25 March 2010 21:34
		Re: [GMCnet] Master Cylinder Pushrod Clearance By: emerystora on Thu, 25 March 2010 21:38
		Re: [GMCnet] Master Cylinder Pushrod Clearance By: Gary Bovee on Thu, 25 March 2010 23:28
		Re: [GMCnet] Master Cylinder Pushrod Clearance By: emerystora on Fri, 26 March 2010 12:18

Previous Topic:	[GMCnet] GMCMH-EFI Google Group
Next Topic:	[GMCnet] GMC Coach - New Braunfels, TX

Goto Forum:

-=] Back to Top [=-

Current Time: Tue Oct 01 11:50:51 CDT 2024

Total time taken to generate the page: 0.01035 seconds