Re: [GMCnet] Bleeding Brakes and the J-23709 Tool [message #63335 is a reply to message #63319] |
Fri, 06 November 2009 21:09 |
Ken Burton
Messages: 10030 Registered: January 2004 Location: Hebron, Indiana
Karma:
|
Senior Member |
|
|
GMCWiperMan wrote on Fri, 06 November 2009 18:07 | Tim,
As shown in this photo:
http://www.gmcmhphotos.com/photos/showphoto.php?photo=5332
the pin only needs to compress a very small spring to open the
metering valve bypass. Almost anything that can be applied to the pin
should depress it: A strong rubber band; a short piece of steel with
a hole in each end for a spring to reach around the other end of the
combination valve; a squeeze-handle clamp; etc. No need to devote a
lot of effort to fabrication.
Ken H.
On Fri, Nov 6, 2009 at 5:05 PM, Tim Pledger <tjsnout@gmail.com> wrote:
> I am bleeding the brakes tomorrow.
>
> Today I hope to fabricate this J-23709 tool.
>
> Does anyone have a drawing or has one to measure? I would be very thankful
> for some rough measurements.
>
> Cheers,
>
> TJ
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
Ken You are still sending duplicate postings. One at 18:06 and one at 18:07
Ken B.
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
|
|
|