Re: Generator Compartment Insulation [message #61995 is a reply to message #61986] |
Tue, 27 October 2009 17:31 |
Rusty
Messages: 197 Registered: October 2005 Location: Philadelphia Pa
Karma:
|
Senior Member |
|
|
I think I paid $80 for a 4x4' piece of aluminum laminated heat insulation 1/4" thick from NAPA . I used Permatext gasket sealer in a spray can to glue it. Cut the pieces. Spray the brown stuff on the coach surface. Let it dry for 5 minutes till its tacky. Fit the piece and snug it up. Aluminum side up. Use a whisk broom to put pressure all over the piece for a few minutes till it sets up good. For the roof of the compartment I cut a piece of thin plywood to match. After I sprayed and placed the piece I held it up with the plywood and braced the plywood up with a 2x4 so I didnt have to hold it. Left it overnite. That was summer of 2008 its still holding.
Rusty
75 Glenbrook
Philadelphia Pa
|
|
|