GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Buzz Box Replacement (PD9245C Wiring Progressive Dynamics)
Re: Buzz Box Replacement [message #371406 is a reply to message #371405] Thu, 08 June 2023 00:40 Go to previous messageGo to previous message
Ken Burton is currently offline  Ken Burton   United States
Messages: 10030
Registered: January 2004
Location: Hebron, Indiana
Karma:
Senior Member
I hate it too.

The battery in this case is sealed. As difficult as it was to disconnect and remove, I am wondering what some Tire Monkey at Walmart, or Sam's, or Costco would do to the fuse block assembly when selling and replacing your battery.

Also it locks you into using the exact same battery as a replacement. Any difference in height like battery caps will not fit.

Another thing that bothered me was ALL of the threaded studs (there were 7 of them of three different sizes) were mildly oxidized. They were difficult to turn the nuts off of. The nuts were cleaning out the threads as I removed them. All of this in 5 years and 50,000 miles. So there may still be some acid fumes coming out of the sealed battery. I could spin them back on with my fingers. I took them off a second time and covered the threads with anti-oxidation grease.

Ken B.


Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Deleting a single pic from a photo site album
Next Topic: Trans Fluid in Final Drive
Goto Forum:
  


Current Time: Fri Sep 27 07:09:19 CDT 2024

Total time taken to generate the page: 0.00864 seconds