Re: GMC A/C belt tensioner advice [message #371262 is a reply to message #371260] |
Mon, 03 April 2023 13:00 |
rjw
Messages: 697 Registered: September 2005
Karma:
|
Senior Member |
|
|
JohnL455 wrote on Mon, 03 April 2023 09:52Here is what I have done with A6, might work with Sanden. Unorthodox but… I take the largest Channel locs I have and open them all the way. I wrap a bit of tape on the one open handle end as a cushion and wedge the end under compressor. Using tool fully open apply pressure to opposite handle to get desired tension. I then take duct tape and tie off the top handle to the hatch opening aluminum. This holds the tension while I snug bolts top and bottom. Hey, it worked.
The basic shape of the Sanden seems similar to the AC6. I don't see any reason why your technique would not work. I have a pretty big channel lock, so I'll give it a try. Thanks for the tip,
Richard
76 Palm Beach
SE Michigan
www.PalmBeachGMC.com
Roller Cam 455, TBI+EBL, 3.42 FD, 4 Bag, Macerator, Lenzi (brakes, vacuum system, front end stuff), Manny Tranny, vacuum step, Tankless + OEM water heaters.
|
|
|