Re: GMC A/C belt tensioner advice [message #371260 is a reply to message #371250] |
Mon, 03 April 2023 08:52 |
JohnL455
Messages: 4447 Registered: October 2006 Location: Woodstock, IL
Karma:
|
Senior Member |
|
|
Here is what I have done with A6, might work with Sanden. Unorthodox but… I take the largest Channel locs I have and open them all the way. I wrap a bit of tape on the one open handle end as a cushion and wedge the end under compressor. Using tool fully open apply pressure to opposite handle to get desired tension. I then take duct tape and tie off the top handle to the hatch opening aluminum. This holds the tension while I snug bolts top and bottom. Hey, it worked.
John Lebetski
Woodstock, IL
77 Eleganza II
|
|
|