[GMCnet] Re: Bath fan [message #370818 is a reply to message #370813] |
Fri, 02 December 2022 17:33 |
Dolph Santorine
Messages: 1236 Registered: April 2011 Location: Wheeling, WV
Karma:
|
Senior Member |
|
|
Hey Dean:
I’m fairly certain that when you remove the escutcheon around the push up housing, that you’ll find a blue wire with +12 volts on it.
Typically, the ground was a zip screw to one of the aluminum spars of the roof.
Check LIVING AREA ELECTRICAL 24B- 3 in the X-7525 manual. Bath Vent Fan.
HTH….
Dolph
DE AD0LF
Wheeling, West Virginia
1977 26’ ex-PalmBeach
Howell EFI & EBL, Reaction Arms, Manny Transmission
“The Aluminum and Fiberglass Mistress”
|[ ]~~~[][ ][] \
"--OO--[]---O-“
> On Dec 2, 2022, at 3:27 PM, Hanson Email wrote:
>
> I have a 1974 Glacier that does not have a power fan in the wet bath. The
> push up vent is there but no electric. I am putting in a power vent. Any
> suggestions on how to wire that up? I can easily connect it to the rear
> light but then the light has to be on for the vent to be on. Not sure that
> is a problem.
>
> Any other thoughts?
>
> Some of you are still on this site as I got great response from my last
> question. Thank you for that.
>
> Dean
>
> Dean hanson
>
> Several models/years
>
> Fremont, ca.
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|