GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Bob Drewes' outer CV boot replacement technique
Re: [GMCnet] Re: Bob Drewes' outer CV boot replacement technique [message #369209 is a reply to message #369208] Tue, 22 March 2022 11:04 Go to previous messageGo to previous message
Richard RV   United States
Messages: 631
Registered: July 2012
Location: Full-timer for 12 years, ...
Karma:
Senior Member
Dave Stragand wrote on Tue, 22 March 2022 10:52
I couldn't find this procedure. Does anyone have a link? Thanks.
http://www.bdub.net/GMCMotorhome.info/front.html#cv

Pertinent part:
"Replace the CV boot with out removing the axle
Jack up the front of the coach, block it, remove wheel (optional), remove the tie rod from the knuckle(optional, but it will give you more room & flexibility), cut the old boot off, with a snap ring pliers, EXPAND snap ring in the outer CV joint and slide axle towards the inner plunge joint, clean as needed, install new boot on axle, slide axle into outer CV joint, snap ring will expand as axle is pushed into CV joint, MAKE SURE SNAP RING IS SEATED, install grease and position CV boot, burp the air out of the boot and clamp it, try to keep the surface for the outer clamp surface as dry as possible. This is about an 1-1/2 hour job per side, good luck. Bob Drewes in SESD"

Thanks

Richard


'77 Birchaven TZE...777; '76 Palm Beach under construction; ‘76 Edgemont waiting its turn
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Window Tinting
Next Topic: belts slip
Goto Forum:
  


Current Time: Sun Jun 16 17:10:33 CDT 2024

Total time taken to generate the page: 0.00459 seconds