Re: Onan Primer Fuse [message #368467 is a reply to message #368458] |
Sat, 15 January 2022 19:41 |
Ken Burton
Messages: 10030 Registered: January 2004 Location: Hebron, Indiana
Karma:
|
Senior Member |
|
|
Actually I have the opposite view. On mine I can hold the prime switch WITHOUT CRANKING the engine I can hear the pump running and slow down when the carb is full. It is a very slow click when it is full. The one time I never heard it slow down was because of a stuck open float / needle and seat. I found out about it with ever trying to start the engine.
My airplane uses the same Bendix pump. The pre-start checklist from Grumman says to start the electric pump. Listen for it an read the fuel pressure gauge for 4-6 PSI. Then use the injection system to squirt fuel direct into the cylinders and start the engine.
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
|
|
|