GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Fuel Injection
[GMCnet] Re: Fuel Injection [message #368321 is a reply to message #368315] Sun, 02 January 2022 23:05 Go to previous messageGo to previous message
jimk is currently offline  jimk   United States
Messages: 6734
Registered: July 2006
Location: Belmont, CA
Karma:
Senior Member
All the throttle body EFI has no Full ignition timing control so don't
expect better mileage.
Without full Ignition timing control, you're dependent on the
original distributor with vacuum and mechanical advance.
We sell ALL the kits and find that the Howell base unit with Knock module
and knock sensor and the EBL Flash drive ECM will deliver better mileage.
Best of all, 90% of the components are readily tors.at your parts store,
while ALL the other throttle body unit are seldom stocked by local parts
distributors.
Keep in mind, your using the MH traveling out of town.

On Sun, Jan 2, 2022 at 5:45 PM Bill Van Vlack
wrote:

> RF_Burns wrote on Sun, 02 January 2022 17:45
>> Add a Vehicle Speed Sensor (VSS) to your EBL and then you can enable
> Lean Cruise and Deceleration fuel cutoff (DFCO). Then you can watch the
>> Instant MPG goto ~14MPG on lean Cruise and 99MPG going down a hill with
> DFCO.
>>
>> I usually run with the truckers here in Canada. So in Ontario on the
> freeways they are required to run speed limiters at 105Kph max. I've seen
>> 12MPG average (US Gallons) on the EBL (which calculated pretty close on
> 2 fill-ups). This was only highway running at a constant speed.
>
> Use WinLog-EBL and you can use the three trip meters that record miles,
> gallons, and mpg. There's a new installer on the website that makes it much
> easier to set up.
>
> --
> Bill Van Vlack
> '76 Royale; Guemes Island, Washington; Twin bed, full (DS) side bath,
> Brazilian Redwood counter and settee tops,455, 6KW generator; new owner a/o
> mid
> November 2015.
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>


--
Jim Kanomata ASE
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.gmcrvparts.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:



Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Re: Hydro max brake booster install pictures
Next Topic: 73 lower ball joints
Goto Forum:
  


Current Time: Fri Sep 27 10:13:26 CDT 2024

Total time taken to generate the page: 0.01034 seconds