GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » EFI and Electronic Ignition Initial Start Up Questions
Re: EFI and Electronic Ignition Initial Start Up Questions [message #367980 is a reply to message #367887] Sun, 12 December 2021 17:28 Go to previous message
jhbridges is currently offline  jhbridges   United States
Messages: 8412
Registered: May 2011
Location: Braselton ga
Karma:
Senior Member
I didn't swap tanks driving my new to me 26', and the gauge was untrustworty in the positive direction. It quit, wouldn't start, so I called Miguel. He told me swap tanks, take the air horn off, and look down the FI throat while tuning the ignition on and back off till I see a squirt of fuel. Took about ten cycles, and a bit of gas shot out. Turned it to start and it fired up instantly. Fortunately, an exit half a mile ahead It was the exit where the Gen Patton museum is located, bought 40+ gallons of gas, did the museum, and hustled on down I 10 to the east, with an eagle eye on the odometer.

--johnny


Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons. Braselton, Ga. I forgive them all, save those who hurt the dogs. They must answer to me in hell
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Patterson
Next Topic: Socket size (12 pt) for front axle output hub bolts?
Goto Forum:
  


Current Time: Fri Jun 21 15:02:07 CDT 2024

Total time taken to generate the page: 0.01344 seconds