GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » EFI and Electronic Ignition Initial Start Up Questions
Re: EFI and Electronic Ignition Initial Start Up Questions [message #367958 is a reply to message #367956] Sat, 11 December 2021 18:43 Go to previous messageGo to previous message
Bill Van Vlack is currently offline  Bill Van Vlack   United States
Messages: 419
Registered: September 2015
Location: Guemes Island, Washington
Karma:
Senior Member
Yes... Quote:
What was wrong and what fixed it ?

Quote:
Tom says: "I did add a new to me spark control dist. I have the original connector attached and one wire to the tach location. It may be my after market Tach, which means I have no connection to the EBL. I will have to review to see if there is any wiring concerns at that location?"
Some more questions... What is a 'spark control distributor'? HEI? HEI with 8-pin module, pigtail, and 4-pin weatherpac connector that connects the new harness and back to the ECM? What is the 'original connector? One of the connectors for power, ground and tach connectors at the coil or the 4-pin harness connector?



Bill Van Vlack '76 Royale; Guemes Island, Washington; Twin bed, full (DS) side bath, Brazilian Redwood counter and settee tops,455, 6KW generator; new owner a/o mid November 2015.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Patterson
Next Topic: Socket size (12 pt) for front axle output hub bolts?
Goto Forum:
  


Current Time: Mon Sep 23 04:48:42 CDT 2024

Total time taken to generate the page: 0.04273 seconds