GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » EFI and Electronic Ignition Initial Start Up Questions
[GMCnet] Re: EFI and Electronic Ignition Initial Start Up Questions [message #367926 is a reply to message #367925] Fri, 10 December 2021 10:06 Go to previous messageGo to previous message
sgltrac is currently offline  sgltrac   United States
Messages: 2797
Registered: April 2011
Karma:
Senior Member
If you have a low oil pressure shut off switch that could be causing you
trouble as well depending upon how it is wired. I had issues with my Howell
+ Ebl upon initial startup until I removed the low oil pressure switch that
I had installed at the same time.

Sully
Bellevue wa

On Fri, Dec 10, 2021 at 7:12 AM wrote:

> Bill,
>
> 1977 Birchaven had an IGN spare spade in the fuse panel. I used that to
> operate the relay on the new ign fuse bus. I attached the pink wire at the
> ALDL to this panel. When the key is on and through the cranking process
> the pink wire gets power. The fuel pump opertes and fuel pressure is up.
>
> I did add a new to me spark control dist. I have the original connector
> attached and one wire to the tach location. It may be my after market Tach,
> which means I have no connection to the EBL. I will have to review to see
> if there is any wiring concerns at that location?
>
> Thank you and everyone for their help.
>
> Take care,
> Tom
> --
> Tom & Oki Katzenberger,
> Kingsville, Maryland,
> 1977 23' Birchaven, 455 C.I.D.
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:



Sully 77 Royale basket case. Future motorhome land speed record holder(bucket list) Seattle, Wa.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Patterson
Next Topic: Socket size (12 pt) for front axle output hub bolts?
Goto Forum:
  


Current Time: Mon Sep 23 04:44:54 CDT 2024

Total time taken to generate the page: 0.01000 seconds