GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » EFI and Electronic Ignition Initial Start Up Questions
Re: EFI and Electronic Ignition Initial Start Up Questions [message #367925 is a reply to message #367887] Fri, 10 December 2021 08:20 Go to previous messageGo to previous message
Tom Katzenberger is currently offline  Tom Katzenberger   United States
Messages: 399
Registered: June 2019
Location: Kingsville, MD
Karma:
Senior Member
Bill,

1977 Birchaven had an IGN spare spade in the fuse panel. I used that to operate the relay on the new ign fuse bus. I attached the pink wire at the ALDL to this panel. When the key is on and through the cranking process the pink wire gets power. The fuel pump opertes and fuel pressure is up.

I did add a new to me spark control dist. I have the original connector attached and one wire to the tach location. It may be my after market Tach, which means I have no connection to the EBL. I will have to review to see if there is any wiring concerns at that location?

Thank you and everyone for their help.

Take care,
Tom


Tom & Oki Katzenberger, Kingsville, Maryland, 1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Patterson
Next Topic: Socket size (12 pt) for front axle output hub bolts?
Goto Forum:
  


Current Time: Fri Jun 21 15:05:57 CDT 2024

Total time taken to generate the page: 0.01019 seconds