GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » EFI and Electronic Ignition Initial Start Up Questions
Re: EFI and Electronic Ignition Initial Start Up Questions [message #367920 is a reply to message #367887] Thu, 09 December 2021 19:29 Go to previous messageGo to previous message
RF_Burns is currently offline  RF_Burns   Canada
Messages: 2277
Registered: June 2008
Location: S. Ontario, Canada
Karma:
Senior Member
Tom,
I and several others have asked if the IGNition wire to the ECM has power during cranking. This is important to check because many circuits in the fuse panel have power with IGNtion ON, but not during cranking... these are actually Accessory power points.

You need to find a power source that comes ON during IGNITION AND CRANKING. Please confirm this, otherwise you will have no spark or fuel during cranking.

If I recall NONE of the Quick-Connect spades in the fuse panel has power during Cranking... you must tap off a fuse. According to the 1977 wiring diagram, only these fuses have power during cranking (IGNition 1)
-Directional Signals (DIR-SIG)
-Backup/Cruise
-Gauges/Trans(mission)

I believe mine (also a 1977) is connected to the Gauges/Trans fuse which is a short fuse at the bottom of fuse panel.


Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.
1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Patterson
Next Topic: Socket size (12 pt) for front axle output hub bolts?
Goto Forum:
  


Current Time: Mon Sep 23 04:47:55 CDT 2024

Total time taken to generate the page: 0.00909 seconds