GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » EFI and Electronic Ignition Initial Start Up Questions
[GMCnet] Re: EFI and Electronic Ignition Initial Start Up Questions [message #367906 is a reply to message #367904] Thu, 09 December 2021 15:59 Go to previous messageGo to previous message
James Hupy is currently offline  James Hupy   United States
Messages: 6806
Registered: May 2010
Karma:
Senior Member
Set the distributor at 10° btdc. Number 1 piston on compression stroke. The
computer should take it from there.
Jim Hupy
Salem, Oregon

On Thu, Dec 9, 2021, 1:55 PM wrote:

> Thanks Dave, Check on fuel. I just ran to Pennsylvania to get 20 gal none
> ethanol fuel due to the fact I don't know how long I will be under
> construction.
>
> I did find the distributor was set with the cap at the #7 position when
> the #1 was up on the compression stroke. I am readjusting so that the cap is
> on #1 when the #1 is up on a compression stroke.
>
> If I get it running should I use a timing light to adjust the timing or
> will the computer take over?
>
> Thanks,
> Tom
> --
> Tom & Oki Katzenberger,
> Kingsville, Maryland,
> 1977 23' Birchaven, 455 C.I.D.
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Patterson
Next Topic: Socket size (12 pt) for front axle output hub bolts?
Goto Forum:
  


Current Time: Fri Jun 21 15:23:13 CDT 2024

Total time taken to generate the page: 0.00587 seconds