GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Steering box centering
Re: Steering box centering [message #367322 is a reply to message #367287] Tue, 26 October 2021 20:13 Go to previous messageGo to previous message
RF_Burns is currently offline  RF_Burns   Canada
Messages: 2277
Registered: June 2008
Location: S. Ontario, Canada
Karma:
Senior Member
I watched JimB's steering videos both parts 1 and 2 this past week. In part 1 he was calling the output shaft the input shaft and he corrected himself a couple of times. He talked about making the pitman arm parallel with the cover mounting surface when I believe he was wanting to reference the flat spot on the input shaft.

In part 2 he came back and tried to clarify the position of the input shaft with the cover mounting surface. Except this time he stated it was the intermediate shaft's pinch bolt groove that you line up to the cover mounting surface. This is not correct, it is the flat milled surface on the input shaft that is to be parallel to the cover mounting surface as shown on page 9-39 of the manual. It would be really nice if the pinch bolt was the reference point, then you could see at a glance, but the pinch bolt is at some random angle that does not match to anything when on high-point.

I hope he clarifies this before people get this messed up... Or if I am wrong, please advise me and I'll delete this post.


Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.
1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Tid Bit. The stock fan clutch
Next Topic: WEATHER MAP
Goto Forum:
  


Current Time: Tue Jul 02 22:24:43 CDT 2024

Total time taken to generate the page: 0.00669 seconds