Re: Gas Tank Vent Mod [message #366987 is a reply to message #366968] |
Mon, 27 September 2021 14:03 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma:
|
Senior Member |
|
|
I just completed the "High "Y" mod. I used Stainless straight tubing, .065 wall thickness and a brass "Y" fitting that had a 1/2" barb on one side. I found the Brass "Y" fitting on Ebay. I wanted to make sure there was no pooling of fuel in the line. I can't comment on its effectiveness, but by all accounts it should vent each tank separately until the bottom of the cockpit floor and just before the 1/2" OEM tube at the gas fill.
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
|
|
|