GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Exhaust bang bang bang (going down steep grades)
[GMCnet] Re: Exhaust bang bang bang [message #366783 is a reply to message #366779] Tue, 14 September 2021 19:21 Go to previous messageGo to previous message
James Hupy is currently offline  James Hupy   United States
Messages: 6806
Registered: May 2010
Karma:
Senior Member
I did that same thing with my 1938 Oldsmobile. Blew out the muffler, and
broke a couple of valve springs. That ended that engine, and allowed me to
swap in a 303 Olds V-8. And Headers, and dual exhaust.
You have something hot enough inside the exhaust system to ignite a
combustible mixture of gasoline and oxygen. If you get rid of either one of
the three things I just mentioned, you will stop the banging. I would
concentrate upon the gasoline source if it were me. High engine rpm on
deceleration creates a very high vacuum with nearly closed throttle plates.
If they are open a bit too far, then air and fuel can enter the exhaust
system unburned, where it is ignited by hot exhaust components. Air can
also enter via worn throttle shaft bushings, even with throttle plates
closed. Time for a very close inspection of your carburetor. Just what I
would do.
Jim Hupy
Salem, Oregon

On Tue, Sep 14, 2021, 4:36 PM Bill Van Vlack
wrote:

> With a couple EFI systems I have, you can turn on or off 'Deceleration
> Enleanment' and allow/disallow that burble. I used to turn off/on the
> ignition
> Dad's Dodge while coasting. BANG! I don't suppose that helped the muffler
> much.
>
> --
> Bill Van Vlack
> '76 Royale; Guemes Island, Washington; Twin bed, full (DS) side bath,
> Brazilian Redwood counter and settee tops,455, 6KW generator; new owner a/o
> mid
> November 2015.
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Axle Rebuild
Next Topic: Radiator cooling fan
Goto Forum:
  


Current Time: Tue Jul 02 02:40:18 CDT 2024

Total time taken to generate the page: 0.01023 seconds