[GMCnet] Re: AC shroud for Coleman 6727A [message #366236 is a reply to message #366233] |
Fri, 20 August 2021 08:36 |
Keith V
Messages: 2337 Registered: March 2008 Location: Mounds View,MN
Karma:
|
Senior Member |
|
|
I bought 2 new covers for my penguins, didn't think it was that bad.
remember any crank will act like a wick and suck a surprising amount water in.
Keith Vasilakes
Mounds View MN
76 exRoyale
MicroLevel
________________________________
From: James Hupy
Sent: Thursday, August 19, 2021 11:52 PM
To: gmclist@list.gmcnet.org
Subject: [GMCnet] Re: AC shroud for Coleman 6727A
It is easier to repair on the inside rather than the outside. Rough it up
with 60 grit, clean it with methyl ethyl ketone peroxide or similar
chemicals like acetone, then use fiberglass mat and epoxy resin. Let it
cure, then use a good body filler on the outside, sand and repaint. Good as
new, except for being 40+ year old plastic.
Jim Hupy
Salem, Oregon
On Thu, Aug 19, 2021, 9:45 PM roy keen wrote:
> New shrouds aren’t cheap if it isn’t too far gone and you need a project
> you could cover it with a layer of fiberglass and resin followed with a
> coat of paint
> --
> Roy Keen
> Minden,NV
> 76 X Glenbrook
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Keith Vasilakes
Mounds View. MN
75 ex Royale GMC
ask me about MicroLevel
Cell, 763-732-3419
My427v8@hotmail.com
|
|
|