[GMCnet] Re: AC shroud for Coleman 6727A [message #366233 is a reply to message #366232] |
Thu, 19 August 2021 23:52 |
James Hupy
Messages: 6806 Registered: May 2010
Karma:
|
Senior Member |
|
|
It is easier to repair on the inside rather than the outside. Rough it up
with 60 grit, clean it with methyl ethyl ketone peroxide or similar
chemicals like acetone, then use fiberglass mat and epoxy resin. Let it
cure, then use a good body filler on the outside, sand and repaint. Good as
new, except for being 40+ year old plastic.
Jim Hupy
Salem, Oregon
On Thu, Aug 19, 2021, 9:45 PM roy keen wrote:
> New shrouds aren’t cheap if it isn’t too far gone and you need a project
> you could cover it with a layer of fiberglass and resin followed with a
> coat of paint
> --
> Roy Keen
> Minden,NV
> 76 X Glenbrook
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|