Re: [GMCnet] Re: Lower Steering Shaft Removal [message #366077 is a reply to message #366073] |
Wed, 11 August 2021 22:10 |
Carl S.
Messages: 4186 Registered: January 2009 Location: Tucson, AZ.
Karma:
|
Senior Member |
|
|
I just recently did this. I bought the Alex Ferarra boot set from Applied GMC and followed the installation instructions. I used the CV joint grease that came with the boot. Very happy with the product:
https://www.gmcrvparts.com/product-p/gfa8082.htm
The lower connection to the steering box can easily be off a spline or even two if you are not careful. It is not on right unless you can slide a 29/64" drill bit through the hole for the clamp bolt. If that drill bit does not go through (the smooth end) it is not lined up correctly. It is a PITA to get it lined up right and I had to walk away from it after the first half dozen attempts. When I went back to it, it went on correctly the second try.
Carl Stouffer
'75 ex Palm Beach
Tucson, AZ.
Chuck Aulgur Reaction Arm Disc Brakes, Quadrabags, 3.70 LSD final drive, Lenzi knuckles/hubs, Dodge Truck 16" X 8" front wheels, Rear American Eagles, Solar battery charging. GMCSJ and GMCMI member
|
|
|