Re: [GMCnet] Re: Lower Steering Shaft Removal [message #366072 is a reply to message #366000] |
Wed, 11 August 2021 12:23 |
EricWaS
Messages: 7 Registered: August 2020 Location: Spokane, WA
Karma:
|
Junior Member |
|
|
jimk wrote on Mon, 09 August 2021 00:19Call me and I will send you several pages and we can discuss.
It is lot tricky than it looks.
Be sure and mark ALL as it is tricky.
On Sun, Aug 8, 2021 at 10:12 PM Eric Schmidt wrote:
> It was touched on, but not discussed... if the steering box is set at the
> high point, and the steering wheel is straight ahead and the clamp bolts are
> positioned as they should be but the cv joint bolt holes do not line up,
> how does one adjust it? My coach wasn't right when I got it, and I am trying
> to get it right. How and what do I index so that it is right? As it is
> right now, the cv joint screw holes are off about 30 degrees. Anyone? Thank
> you!
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
--
Jim Kanomata ASE
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.gmcrvparts.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Thanks for the offer of the call Jim! I will try to call when I am standing in from of my moho. Is any time any better than another? PM me?
The real problem is that it has been apart before by a PO, and I believe it wasn't assembled correctly at that time. The documents that I could find rely on everything being marked as they are dis-assembled. The steering shaft came from another vendor when he was clearing out his inventory, and the cv joint binds a little, so it possibly is not clocked the same as it came apart?
Thanks, Eric
|
|
|