Re: Water heater engine hose [message #365949 is a reply to message #365937] |
Sat, 07 August 2021 17:11 |
mrgmc3
Messages: 210 Registered: September 2013 Location: W Washington
Karma:
|
Senior Member |
|
|
Yes! In a typical GMC 26 foot with right side wet bath, you must use your old hose to pull the new hose through. Use a piece of tubing on the ID and tape the hose ends together, then pull. You can go either way but if you pull the old hose completely out you’ll never thread the new stuff in by itself without some major disassembly.
Chris Geils - Twin Cities / W Wa
1978 26' Kingsley w/ very few mods; PD9040, aux trans cooler, one repaint in stock colors, R134a, Al rad, Alcoas, 54k mi
|
|
|