[GMCnet] Re: Tips for installing engine vents [message #364676 is a reply to message #364674] |
Mon, 14 June 2021 00:17 |
richshoop
Messages: 190 Registered: April 2017
Karma:
|
Senior Member |
|
|
Before you buy ANY look a like Multi-tool.... Be sure to test it in the material you intend to cut. Some of them vibrate the handle more than the blade! If you have ever used an original Fein Multi-tool, you will be hard pressed to buy anything else.
I did eventually buy a battery powered one and got a dewalt 20V lithium battery powered one and it is ok. But if I need to cut something tough, I drag out the extension cord and use the Fein. Saw blades for these things are also expensive.
> On 06/13/2021 6:38 PM Bruce Hart wrote:
>
>
> Multi-tool is your friend here.
>
> Milwaukee M12 12-Volt Lithium-Ion Cordless Oscillating Multi-Tool
> (Tool-Only)-2426-20 - The Home Depot
>
>
> On Sun, Jun 13, 2021 at 7:13 PM Scott Nutter wrote:
>
>> I can’t tell you how many hours I’ve sat underneath the front quarter
>> panels eyeballing where to cut. I will only cut flat panels, nothing with a
>> 90 degree angle on it.. I just don’t see the logic in cutting.. it would
>> only be a couple inch of vent effectiveness to where the wheel well insert
>> is. And that is with the long/skinny and/or shorter/wider vents. But to
>> be honest, I was only looking at the rear area in the quarter panel.
>> If anyone has data to justify cutting, I am all ears.
>> Scott.
>> --
>> Scott Nutter
>> 1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final
>> drive, Quad bags, tankless water heater, everything Lenzi. Alex Ferrera
>> installed MSD Atomic EFI
>> Houston, Texas
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>>
>
>
> --
> Bruce Hart
> 1976 Palm Beach
> LaGrange, Wyoming
> GMC=Genetically Modified Chevy
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|