[GMCnet] Re: Tips for installing engine vents [message #364674 is a reply to message #364673] |
Sun, 13 June 2021 20:38 |
Bruce Hart
Messages: 1501 Registered: October 2011 Location: La Grange, Wyoming
Karma:
|
Senior Member |
|
|
Multi-tool is your friend here.
Milwaukee M12 12-Volt Lithium-Ion Cordless Oscillating Multi-Tool
(Tool-Only)-2426-20 - The Home Depot
On Sun, Jun 13, 2021 at 7:13 PM Scott Nutter wrote:
> I can’t tell you how many hours I’ve sat underneath the front quarter
> panels eyeballing where to cut. I will only cut flat panels, nothing with a
> 90 degree angle on it.. I just don’t see the logic in cutting.. it would
> only be a couple inch of vent effectiveness to where the wheel well insert
> is. And that is with the long/skinny and/or shorter/wider vents. But to
> be honest, I was only looking at the rear area in the quarter panel.
> If anyone has data to justify cutting, I am all ears.
> Scott.
> --
> Scott Nutter
> 1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final
> drive, Quad bags, tankless water heater, everything Lenzi. Alex Ferrera
> installed MSD Atomic EFI
> Houston, Texas
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
--
Bruce Hart
1976 Palm Beach
LaGrange, Wyoming
GMC=Genetically Modified Chevy
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Bruce Hart
1976 Palm Beach
1977 28' Kingsley
La Grange, Wyoming
|
|
|