Re: Tips for installing engine vents [message #364673 is a reply to message #364669] |
Sun, 13 June 2021 20:12 |
Scott Nutter
Messages: 782 Registered: January 2015 Location: Houston/San Diego
Karma:
|
Senior Member |
|
|
I can’t tell you how many hours I’ve sat underneath the front quarter panels eyeballing where to cut. I will only cut flat panels, nothing with a 90 degree angle on it.. I just don’t see the logic in cutting.. it would only be a couple inch of vent effectiveness to where the wheel well insert is. And that is with the long/skinny and/or shorter/wider vents. But to be honest, I was only looking at the rear area in the quarter panel.
If anyone has data to justify cutting, I am all ears.
Scott.
Scott Nutter
1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final drive, Quad bags, Dave Lenzi super duty mid axle disc brakes, tankless water heater, everything Lenzi. Alex Ferrera installed MSD Atomic EFI
Houston, Texas
|
|
|