[GMCnet] Re: Tips for installing engine vents [message #364671 is a reply to message #364669] |
Sun, 13 June 2021 18:05 |
stu@97381.com, Emery
Messages: 232 Registered: June 2020
Karma:
|
Senior Member |
|
|
Drilling a hole in the corners is a good idea. A jigsaw (saber saw) will work just as well and might be faster than a Dremel.
Emery Stora
> On Jun 13, 2021, at 4:06 PM, Ken Morefield wrote:
>
> I bought some stainless engine vents from Sirum and am looking for tips on cutting the hole to install. I’ve seen the tips for installing as high
> as possible, and as far back as possible. I’m thinking of figuring out the best placement, then putting masking tape down where the cut will go,
> then drawing the cut outline over the tape. Drill or hole saw the corners, then a dremel with a diamond disk blade for cutting the rest. Any other
> pointers? I want to get it right, as there aren’t really any do-overs!
> --
> 1975 - 26’ Eleganza II
> Unsure of what upgrades may have been done. I'm working on sorting that out in the coming months.
> Ken Morefield - Redding, CA
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|