Re: Tips for installing engine vents [message #364670 is a reply to message #364669] |
Sun, 13 June 2021 18:15 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma:
|
Senior Member |
|
|
Ken,
It looks as though you have done a great job thinking through this. I can only say attention to measurements, mark the masking tape and double check before drilling and cutting.
I can't think of any thing I would do differently.
Make sure you check the back side that you are clear of anything structural or the like.
Good luck,
Tom K.
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
|
|
|