Tips for installing engine vents [message #364669] |
Sun, 13 June 2021 17:05 |
Ken M
Messages: 32 Registered: December 2019 Location: Redding, CA
Karma:
|
Member |
|
|
I bought some stainless engine vents from Sirum and am looking for tips on cutting the hole to install. I’ve seen the tips for installing as high as possible, and as far back as possible. I’m thinking of figuring out the best placement, then putting masking tape down where the cut will go, then drawing the cut outline over the tape. Drill or hole saw the corners, then a dremel with a diamond disk blade for cutting the rest. Any other pointers? I want to get it right, as there aren’t really any do-overs!
1975 - 26’ Eleganza II
Unsure of what upgrades may have been done. I'm working on sorting that out in the coming months.
Ken Morefield - Redding, CA
|
|
|