GMCforum: GMCnet » Torsion Bar Adjustment

Home » Public Forums » GMCnet » Torsion Bar Adjustment (Longer Bolt for Pork Chop Adjustment)

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Re: Torsion Bar adjustment [message #363993 is a reply to message #136511]

Fri, 14 May 2021 11:54

James Hupy

Messages: 6806
Registered: May 2010

Karma:

Senior Member

Unloading tool allows you to keep your adjustments fairly close. Saves
time.
Jim Hupy
Salem, Oregon

On Fri, May 14, 2021, 9:49 AM Billy Massey wrote:

> I'd unload it.
>
> bdub
> http://www.bdub.net/torsionbarunloader/
>
> On Fri, May 14, 2021 at 11:45 AM wrote:
>
>> Speaking with an Olds Toronado buff over coffee this morning, asked him
> if
>> he had a torsion bar unloading tool I could borrow.
>>
>> He didn't have one, but suggested if I was slackening (lowering the front
>> end) seemed reasonable to him that as the tension would be decreasing so
> I
>> wouldn't need the unload tool.
>>
>> Any thoughts on this?
>>
>> Larry
>>
>>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:

Report message to a moderator

[Message index]

		Torsion Bar Adjustment By: hal kading on Thu, 28 July 2011 22:42
		Re: Torsion Bar Adjustment By: GMCNUSA on Thu, 28 July 2011 22:52
		Re: [GMCnet] Torsion Bar Adjustment By: powerjon on Fri, 29 July 2011 20:50
		Re: [GMCnet] Torsion Bar Adjustment By: Steven Ferguson on Sat, 30 July 2011 07:45
		Re: [GMCnet] Torsion Bar Adjustment By: hal kading on Sat, 30 July 2011 22:22
		Re: [GMCnet] Torsion Bar Adjustment By: Kosier on Sat, 30 July 2011 22:56
		Re: [GMCnet] Torsion Bar Adjustment By: Steven Ferguson on Sun, 31 July 2011 06:55
		Re: [GMCnet] Torsion Bar Adjustment By: powerjon on Fri, 29 July 2011 20:47
		[GMCnet] Re: Torsion Bar adjustment By: James Hupy on Fri, 14 May 2021 11:54

Previous Topic:	Heater core replacement
Next Topic:	fuel gauge pegged to beyond full

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Jul 05 03:26:10 CDT 2024

Total time taken to generate the page: 0.00725 seconds