GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Centering the steering box (what does that mean?)
Re: Centering the steering box [message #363652 is a reply to message #363650] Sat, 24 April 2021 10:18 Go to previous messageGo to previous message
boybach is currently offline  boybach   
Messages: 566
Registered: December 2020
Location: Vancouver Island
Karma:
Senior Member
Matt Colie wrote on Sat, 24 April 2021 06:34
Larry,

Be aware that the U-joint can be made to "fit" even when it is a tooth off. (Mine was two off but someone made it fit by hammering the bolt through.) I think that the manual specifies a drill size to fit in there, but I can't find it as I write.

Matt
We put the drill bit through before inserting the bolt, Matt.

cheers

Larry


Larry - Victoria BC - 1977 ex-Palm Beach "Ol' Leaky" 40,000 miles, PO said everything working but forgot the word NOT. Atwood helium fridge, water heater & furnace. SS exhaust system, Onan, Iota Converter, R134A, New fuel lines & heat exchange hoses
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: No contact temp sensor
Next Topic: Fuel sending unit lock ring wrench
Goto Forum:
  


Current Time: Fri Jul 05 03:35:17 CDT 2024

Total time taken to generate the page: 0.05934 seconds