GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Centering the steering box (what does that mean?)
Re: [GMCnet] Re: Centering the steering box [message #363642 is a reply to message #363639] Fri, 23 April 2021 23:19 Go to previous messageGo to previous message
boybach is currently offline  boybach   
Messages: 566
Registered: December 2020
Location: Vancouver Island
Karma:
Senior Member
jimk wrote on Fri, 23 April 2021 20:30
The cam washer is never welded to the bolt.
Coach and Toro is same on the upper A frame.
Well this cam must have been a prototype then, because it was definitely attached to the bolt head permanently ...plus the bolt didn't have a flat at that end either, so there would be no way to get that cam locked in position unless it was attached.

I'll post a pic tomorrow and you can see for yourself.

Larry


Larry - Victoria BC - 1977 ex-Palm Beach "Ol' Leaky" 40,000 miles, PO said everything working but forgot the word NOT. Atwood helium fridge, water heater & furnace. SS exhaust system, Onan, Iota Converter, R134A, New fuel lines & heat exchange hoses
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: No contact temp sensor
Next Topic: Fuel sending unit lock ring wrench
Goto Forum:
  


Current Time: Fri Jul 05 02:35:25 CDT 2024

Total time taken to generate the page: 0.01159 seconds