GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Centering the steering box (what does that mean?)
Re: Centering the steering box [message #363568 is a reply to message #363521] Tue, 20 April 2021 23:01 Go to previous messageGo to previous message
boybach is currently offline  boybach   
Messages: 566
Registered: December 2020
Location: Vancouver Island
Karma:
Senior Member
Ok, well I had a good look at the Mueller steering inspection guide and from his description/picture of the spline bolt position on the U-joint I believe my steering box could be 60 or so degrees off center. I intend to correct this if I can.

As I understand it, the pitman arm and the drag link have to be separated so I can center the box - I'm guessing I need a pickle fork to do that?

Larry



Larry - Victoria BC - 1977 ex-Palm Beach "Ol' Leaky" 40,000 miles, PO said everything working but forgot the word NOT. Atwood helium fridge, water heater & furnace. SS exhaust system, Onan, Iota Converter, R134A, New fuel lines & heat exchange hoses
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: No contact temp sensor
Next Topic: Fuel sending unit lock ring wrench
Goto Forum:
  


Current Time: Wed Oct 02 14:55:25 CDT 2024

Total time taken to generate the page: 0.00896 seconds