[GMCnet] Re: Onan generator not putting out power [message #363201 is a reply to message #363200] |
Sat, 03 April 2021 11:15 |
jimk
Messages: 6734 Registered: July 2006 Location: Belmont, CA
Karma:
|
Senior Member |
|
|
Mark,
We can send over the instruction on where the Bridge Rectifier is located
and how to modify the connectors.
Trusting the terminals is ok , but it is not that easy as the legs normally
do not line up.
On Sat, Apr 3, 2021 at 9:00 AM Bruce Hislop wrote:
> Here is a link to photos of the OEM and mods to the replacement.
>
> Two of the pins are labeled + (positive) and - (Negative). Orient the
> original and replacement rectifiers so those pins are in the same position.
> Note the ones that need to be twisted to match the original.
>
> In this photo, the original (OEM) is on the left. A new one is in the
> center, and a new one modified with twisted pins is on the right.
>
> You can buy this from any electronic distributor for about $2.50 each.
> I'm kinda partial to DigiKey because of the fast & inexpensive shipping. Get
> one rated at 25 Amps and 1000 volts. The high voltage rating may save the
> replacement next time the generator is shut down under load.
>
> http://www.gmcmhphotos.com/photos/onan/p17103.html
>
> --
> Bruce Hislop
> ON Canada
> 77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.1 ton front end
> http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
> My Staff says I never listen to them, or something like that
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.gmcrvparts.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|