[GMCnet] Re: Wheel Nuts [message #362827 is a reply to message #362826] |
Sun, 14 March 2021 22:19 |
jimk
Messages: 6734 Registered: July 2006 Location: Belmont, CA
Karma:
|
Senior Member |
|
|
You never use a flat surface not on an Aluminum wheel as it cuts into
the hole on the wheel has a tapered hole, then you use a tapered nut.
On Sun, Mar 14, 2021 at 8:08 PM Douglas Smith wrote:
> Larry,
> If they are stock steel wheel lug nuts the ION lug nut wrench probably
> will not fit. I just bought a set of ION's from JimK (Love them) but the lug
> nuts are a smaller size than my old 16.5 standard wheel lug nuts. I called
> Nick to confirm the recommended torque on the ION lug nuts and it is 145
> foot/lbs. I always needed a 3 foot cheeter bar to break loose the steel
> wheel lug nuts, but my torque wrench is enough for the ION's. HTH
> Doug
> --
> Douglas & Virginia Smith
> dsmithy18 at gmail
> Lincoln Nebraska
> ’73 “Canyonlands” since ‘95: "Wanabizo";
> Quadrabag/6 wheel disks/3:70 final/Paterson QuadraJet/Thorley’s/Alloy
> wheels(finally!)/Sundry other
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
--
Jim Kanomata
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.gmcrvparts.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|