GMCforum: GMCnet » 1 Ton Conversion Question

Home » Public Forums » GMCnet » 1 Ton Conversion Question

Show: Today's Messages :: Polls :: Message Navigator

Re: 1 Ton Conversion Question [message #362472 is a reply to message #362459]

Sun, 21 February 2021 21:22

Ken Burton

Messages: 10030
Registered: January 2004
Location: Hebron, Indiana

Karma:

Senior Member

I replaced ALL of the rubber bushings with urethane years ago. It was not a bad job. Bushings pressed easily with a vice and used no special tools or spacers. I spent more time sandblasting and painting the control arms while I had it apart than I did pressing bushings.

Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana

Report message to a moderator

[Message index]

		1 Ton Conversion Question By: Tom Katzenberger on Sun, 21 February 2021 08:35
		Re: 1 Ton Conversion Question By: JohnS on Sun, 21 February 2021 11:22
		Re: [GMCnet] 1 Ton Conversion Question By: Ken Henderson on Sun, 21 February 2021 11:28
		Re: [GMCnet] 1 Ton Conversion Question By: jimk on Sun, 21 February 2021 12:58
		Re: 1 Ton Conversion Question By: RF_Burns on Sun, 21 February 2021 14:24
		Re: [GMCnet] 1 Ton Conversion Question By: James Hupy on Sun, 21 February 2021 17:19
		Re: 1 Ton Conversion Question By: JohnL455 on Sun, 21 February 2021 18:57
		Re: 1 Ton Conversion Question By: Ken Burton on Sun, 21 February 2021 21:22
		Re: 1 Ton Conversion Question By: Husker92592 on Sun, 21 February 2021 22:33
		Re: 1 Ton Conversion Question By: Tom Katzenberger on Mon, 22 February 2021 10:36
		Re: 1 Ton Conversion Question By: Larry on Mon, 22 February 2021 10:58
		Re: 1 Ton Conversion Question By: Tom Katzenberger on Mon, 22 February 2021 13:11

Previous Topic:	Double Roller Timing Chain Kit with Gaskets?
Next Topic:	[GMCnet] Air ride

Goto Forum:

-=] Back to Top [=-

Current Time: Sun Oct 06 01:10:57 CDT 2024

Total time taken to generate the page: 0.00496 seconds