GMCforum: GMCnet » Machining Brake Drums

Home » Public Forums » GMCnet » Machining Brake Drums (Machining Brake Drums)

Show: Today's Messages :: Polls :: Message Navigator

Re: Machining Brake Drums [message #361916 is a reply to message #361788]

Fri, 22 January 2021 08:48

TR 1

Messages: 348
Registered: August 2015
Location: DFW

Karma:

Senior Member

jhbridges wrote on Fri, 15 January 2021 07:51

And actually, to properly true a disc, it should be trued on the vehicle. Which we used to do with the racer. Takes some 'doing' because you need a rigid grinder stand and a way to spin the disc.
--johnny

Snap on and some others used to make a tool for this...

https://www.ebay.com/itm/snap-on-ya180-kwik-lathe-on-the-car-rotor-lathe-/313314171051

Mark S. '73 Painted Desert, Manny 1 Ton Front End, Howell Injection, Leigh Harrison 4bag and Rear Brakes, Fort Worth, TX

Report message to a moderator

[Message index]

		Machining Brake Drums By: Ken M on Wed, 13 January 2021 17:55
		Re: [GMCnet] Machining Brake Drums By: Bruce Hart on Wed, 13 January 2021 18:01
		Re: Machining Brake Drums By: JohnL455 on Wed, 13 January 2021 18:59
		Re: [GMCnet] Machining Brake Drums By: Bruce Hart on Wed, 13 January 2021 19:45
		Re: [GMCnet] Machining Brake Drums By: Ken Henderson on Wed, 13 January 2021 23:33
		Re: Machining Brake Drums By: jhbridges on Thu, 14 January 2021 16:54
		Re: [GMCnet] Machining Brake Drums By: Rob on Thu, 14 January 2021 17:07
		Re: [GMCnet] Machining Brake Drums By: James Hupy on Thu, 14 January 2021 19:01
		Re: Machining Brake Drums By: jhbridges on Fri, 15 January 2021 07:51
		Re: Machining Brake Drums By: TR 1 on Fri, 22 January 2021 08:48
		Re: Machining Brake Drums By: Ken M on Fri, 15 January 2021 19:48
		Re: Machining Brake Drums By: Rick Staples on Fri, 15 January 2021 20:45
		Re: Machining Brake Drums By: USAussie on Tue, 19 January 2021 07:33
		Re: Machining Brake Drums By: uprooted on Tue, 19 January 2021 11:25
		Re: Machining Brake Drums By: jhbridges on Fri, 22 January 2021 10:13

Previous Topic:	Faucet rebuild kits?
Next Topic:	[GMCnet] Alternator Question (just curious)

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Jun 28 22:01:44 CDT 2024

Total time taken to generate the page: 0.01906 seconds