GMCforum: GMCnet » Machining Brake Drums

Home » Public Forums » GMCnet » Machining Brake Drums (Machining Brake Drums)

Show: Today's Messages :: Polls :: Message Navigator

Re: Machining Brake Drums [message #361848 is a reply to message #361800]

Tue, 19 January 2021 11:25

uprooted

Messages: 72
Registered: December 2019
Location: Hilliard, OH

Karma:

Member

+1 bought new drums from applied because on of mine had a deep groove. Did have to get them trued. I did notice they were lighter than the OEM. Is this a consideration? I put the new, lighter drums on the middle axle (because hey, they're new) and the original heavier drums on the rear. Wondering now if I should have done that the other way with the old drums with more mass up front due to increased braking work that is done / more heat to be dissipated

Corey P / Hilliard, OH / 1974 Glacier 26' / 3.70 FD / ION Wheels

Report message to a moderator

[Message index]

		Machining Brake Drums By: Ken M on Wed, 13 January 2021 17:55
		Re: [GMCnet] Machining Brake Drums By: Bruce Hart on Wed, 13 January 2021 18:01
		Re: Machining Brake Drums By: JohnL455 on Wed, 13 January 2021 18:59
		Re: [GMCnet] Machining Brake Drums By: Bruce Hart on Wed, 13 January 2021 19:45
		Re: [GMCnet] Machining Brake Drums By: Ken Henderson on Wed, 13 January 2021 23:33
		Re: Machining Brake Drums By: jhbridges on Thu, 14 January 2021 16:54
		Re: [GMCnet] Machining Brake Drums By: Rob on Thu, 14 January 2021 17:07
		Re: [GMCnet] Machining Brake Drums By: James Hupy on Thu, 14 January 2021 19:01
		Re: Machining Brake Drums By: jhbridges on Fri, 15 January 2021 07:51
		Re: Machining Brake Drums By: TR 1 on Fri, 22 January 2021 08:48
		Re: Machining Brake Drums By: Ken M on Fri, 15 January 2021 19:48
		Re: Machining Brake Drums By: Rick Staples on Fri, 15 January 2021 20:45
		Re: Machining Brake Drums By: USAussie on Tue, 19 January 2021 07:33
		Re: Machining Brake Drums By: uprooted on Tue, 19 January 2021 11:25
		Re: Machining Brake Drums By: jhbridges on Fri, 22 January 2021 10:13

Previous Topic:	Faucet rebuild kits?
Next Topic:	[GMCnet] Alternator Question (just curious)

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Sep 28 17:18:17 CDT 2024

Total time taken to generate the page: 0.00788 seconds