GMCforum: GMCnet » Machining Brake Drums

Home » Public Forums » GMCnet » Machining Brake Drums (Machining Brake Drums)

Show: Today's Messages :: Polls :: Message Navigator

Re: Machining Brake Drums [message #361800 is a reply to message #361799]

Fri, 15 January 2021 20:45

Rick Staples

Messages: 126
Registered: May 2014
Location: Johnstown, Colorado, USA

Karma:

Senior Member

Ken,
Jim K has replacement drums. I put 4 on years ago. Recommend truing on a brake lathe pilotted on the bearing races after bolting on.

My 2¢,
Rick Staples

Rick Staples, '75 Eleganza, Johnstown, CO "Advice is a dangerous gift, even from the Wise to the Wise, and all paths may run ill." -Tolkien

Report message to a moderator

[Message index]

		Machining Brake Drums By: Ken M on Wed, 13 January 2021 17:55
		Re: [GMCnet] Machining Brake Drums By: Bruce Hart on Wed, 13 January 2021 18:01
		Re: Machining Brake Drums By: JohnL455 on Wed, 13 January 2021 18:59
		Re: [GMCnet] Machining Brake Drums By: Bruce Hart on Wed, 13 January 2021 19:45
		Re: [GMCnet] Machining Brake Drums By: Ken Henderson on Wed, 13 January 2021 23:33
		Re: Machining Brake Drums By: jhbridges on Thu, 14 January 2021 16:54
		Re: [GMCnet] Machining Brake Drums By: Rob on Thu, 14 January 2021 17:07
		Re: [GMCnet] Machining Brake Drums By: James Hupy on Thu, 14 January 2021 19:01
		Re: Machining Brake Drums By: jhbridges on Fri, 15 January 2021 07:51
		Re: Machining Brake Drums By: TR 1 on Fri, 22 January 2021 08:48
		Re: Machining Brake Drums By: Ken M on Fri, 15 January 2021 19:48
		Re: Machining Brake Drums By: Rick Staples on Fri, 15 January 2021 20:45
		Re: Machining Brake Drums By: USAussie on Tue, 19 January 2021 07:33
		Re: Machining Brake Drums By: uprooted on Tue, 19 January 2021 11:25
		Re: Machining Brake Drums By: jhbridges on Fri, 22 January 2021 10:13

Previous Topic:	Faucet rebuild kits?
Next Topic:	[GMCnet] Alternator Question (just curious)

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Sep 28 17:13:44 CDT 2024

Total time taken to generate the page: 0.00470 seconds